Search found 20 matches

Make sure you connect the +5V and Gnd pins correctly.

If you connect the power pins wrongly and you power up there goes your SHT11.

Hansolo

How do you confirm this? Did you compare the reading with a calibrated thermo-hygrometer?

Hansolo

Can someone help me to report this case to the police dept? I am from Singapore.

I paid by PayPal and I am trying to get a refund from them.

Apparently a member of Portland Area Robotic Societ ...

Thanks for the tip.

I will contact pay pal to get back my money.

Hansolo

Beware folks.

I think Mark III Robot Shop is a con shop. I had ordered approx. USD100.00 worth of goods more than 6 weeks ago but the order never came. I tried writing more than 10 e-mails to them ...

No, I haven't but have you tried contacting your credit card company or pay pal?

I had paid via pay pal and the payment is already through.

Does any of you buy stuffs from Mark III Robot Store (http://www.junun.org/MarkIII/)? Is this an on-line con shop?

I ordered a few items from them about a month ago but the order never came. I wrot ...

Can you explain a little bit more detail of what the software is trying to achieve and how to use it?

I am doing a project using temperature sensor and interested in codes for calibrating the senso ...

I proved the routine with a sht71. At the moment it works perfectly. If I find some error I send a PM to you.

Greetings from Mexico

Thanks for your feedback.

This driver is for the 128x64 GLCD from Xiamen Ocular which is supplied as optional item when purchasing the Mikroelektronika EasyPic 4 Board.

This driver is modified from the Hantronix driver supp ...

The driver was modified because in the Mikroelektronika EasyPic4 Board the LCD R/W is permanently wired to Gnd.

The original LCD.C driver uses the R/W pin to communicate.

Hope this is useful : ...

I did notice that (sort of) after I posted and actually changed a couple of the higher level functions to get it working instead:

// Purpose: Get a byte of data from the display at the addre ...

This driver should also work for SHT11, SHT71 and SHT15 as these sensors are using the same communication protocol.

I had tested these codes with PIC16F877A but should work with other PICs as well ...

I posted the codes for sharing and I am not selling it.
I hope you do not mind.
Thanks.

you must carry forward the GPL license and as well as the copyright(s) of the original author(s).

jds- ...

I posted the codes for sharing and I am not selling it.

I hope you do not mind.

Thanks.